PRODUCT PAGE SITE DIRECTORY
TUBING SUPPORT CLAMPS
Plastic clamps with stainlless steel nails for attaching 1/4" tubing or 1/2" tubing to wood.
UV Resistant plastic hangers used to suspend 1/2" or 3/4" mainline tubing on trellis wire. These hangers are commonly used in vineyards and orchards.
Sprinklers, Sprayers and Misters sometimes need to be raised above surrounding plants to water evenly and without obstruction. That is the purpose of the stakes and risers on this page. The Clip, Straight and EZ Stakes are sturdy enough to be hammered into the soil if necessary. Pop-up risers stay hidden or low-profile until irrigation is on.
Sprayers on stakes give good results. These pop-up risers (pictured to the right--housing not connected) give the advantage of stakes but remain hidden and out of harms way until the irrigation system is working. Then the rigid riser "pops-up" to elevate the sprinkler head 9" or 5" inches above ground. These risers can be used with 10/32 threaded base sprayers (Spectrum, Vari-Jets, Mini-Jets, and even Schrubblers and Mini-Misters). Connect to irrigation system (at base of buried riser) with our 1/4" poly tubing. Operates between 15-50 PSI. Both 5" and 9" models come with a protective housing that will protect the sprinkler head when not in its extended position, or are available without. Risers are installed with the top 1" showing above soil level.
(10) 6" Support Stakes
The groove will hold 1/4" tubing or a Rigid Riser
A Clip Stake with 3 feet of heavy-walled vinyl tubing a transfer barb attached. Just install a sprayer or mister. Fast and easy to use.
(5) 13" Easy Stake (w. 3' tube)
A complete stake assembly. Fast and easy to use. Includes 3 feet of heavy walled vinyl tubing with a transfer barb inserted, attached to a Clip Stake. All you need is the sprayer or mister!
MINI SPRINKLER SUPPORT KIT
13" or 36"
A complete stake assembly that includes a plastic stake, 1/4" flexible vinyl tubing and a transfer barb. This Mini-Sprinkler Support Kit is meant to be used only for the Ein Dor Mini-Sprinklers and Wing sprinklers
13" MESK (13" plastic stake w/press fit barb & 3' tube)
MINI SPRINKLER SUPPORT KIT
TUBING HOLD DOWNS
These are used to keep 1/2" and 3/4" tubing in place.
MICRO-TUBING HOLD DOWNS
Used to keep 1/4" tubing in place.
To go from hose connection directly to 1/4" tubing:
3/4" HOSE to 1/4" TUBE CONNECTION
(5) Hose x 1/4" barb (without Screen)
USING SUPPORT KIT
To install Mini Sprinkler Heads insert the colored-end (spinner) into the press-fit receptacle on the bridge and press down firmly.
MINI SPRINKLER HEAD
Mini Sprinkler Support Kit Detail
PRESS FIT BARB
This barb, which is part of the MESK (Mini Ein-Dor Support Kit) can be fitted into an end of 1/4" mini-tubing or can be inserted directly into mainline tubing to enable use of Ein Dor Mini-Sprinkler Heads or Wing Sprinklers in the irrigation system..
PRESS FIT BARBS